1·METHODS Orthogonal design was used with the adhesion force as the index in the experiment.
方法采用正交设计法，以黏着力为指标，对巴布剂基质配比进行实验研究。
2·The compositions have greatly surpassed the properties including water-resistance, weather durability and adhesion force.
涂料耐水性、耐候性、附着力等性能均超过相应国家标准。
3·It was found that the adhesion force between the spheres and the chip surface was affected by the ligand surface concentration.
实验观察到微球与基片表面的结合力受到配基面密度的影响，说明发生结合的是多对而非单对蛋白质分子。
4·With the increase of the sintering temperature, the adhesion force of Ni electrodes enhances, and the square resistance decreases.
结果表明， 随着烧结温度的增加， 镍电极附着力逐渐增大， 方阻逐渐下降；
5·In this paper, the viscosity, adhesion force and film properties of the acetate starches size are tested, and the test results are analysed.
本文对醋酸酯淀粉浆液的粘度、粘着力及浆膜性能进行了测试，并对测试结果进行了分析。
6·TOP BEST-665 has high surface adhesion force on vacuum bag and a variety of tools. It is cost-effective and shows excellent sealing performance.
TOP BEST-665密封胶带对各种真空袋及复合工具都有高的表面粘着力、优异密封性，是一款高性价比的密封胶带。
7·It may be due to an ICAM 1 accumulation on the microvascular endothelial cells and thus an enhancement of adhesion force during the course of disease.
这有可能是发病过程中ICAM - 1大量表达于内皮细胞表面，导致内皮细胞-白细胞粘附增加的结果。
8·The relative adhesion force of biofouling increases with the increasing of molecular weight and reduces with the increasing of content of silicone oil;
附着生物的相对结合力随着硅油分子量的增加而增大，随着硅油含量的增加而降低；
9·The adhesion force that the sodium lactate produce on the small size of quartz particles is much stronger, which could cause contact failure more likely.
乳酸钠对小粒径石英颗粒粘着作用更强，更易导致触点失效。
10·It is driven not by the adhesion force from the contact between wheel and rail, but by the electromagnetic force from reaction plate which is mounted in track.
它不是由轮轨间的粘着力驱动，而是由安装在轨道的反应板产生的电磁推力驱动的。
1·The compositions have greatly surpassed the properties including water-resistance, weather durability and adhesion force.
涂料耐水性、耐候性、附着力等性能均超过相应国家标准。
2·With the increase of the sintering temperature, the adhesion force of Ni electrodes enhances, and the square resistance decreases.
结果表明， 随着烧结温度的增加， 镍电极附着力逐渐增大， 方阻逐渐下降；